Prerequisites

Students who attend this advanced course must have experience in configuring Cisco IOS software and have met the following prerequisites: Certification as a CCNA or the equivalent knowledge. Basic knowledge of the Windows operating system Familiarity with the networking and security terms and concepts (the concepts are learned in prerequisite training or by reading industry publications)

Course Content

Given an example of Cisco's defense in depth, the learner will explain how Cisco IPS protects network devices from attacks. Given an IPS sensor appliance, the learner will install the appliance in the network and initialize it. Use IDM to configure basic sensor settings. The learner will use IDM to configure built-in signatures to meet the requirements of a given security policy. The learner will describe the functions of signature engines and their parameters. The learner will use IDM to tune and create signatures to meet the requirements of a given security policy. Given a scenario, the learner will use IDM to tune a sensor to work optimally in the network. Given a scenario, the learner will use the Monitoring Center for Security and Cisco Threat Response to maximize alarm management efficiency. The learner will explain blocking concepts and use IDM to configure blocking for a given scenario. The learner will install the NM-CIDS in a router and initialize it. The learner will install the module in a Cisco Catalyst 6500 Switch and initialize it. The learner will use a Cisco Catalyst 6500 Switch to capture network traffic for intrusion prevention analysis. The learner will install and recover the sensor software image and perform service pack and signature updates. The learner will use the CLI and IDM to verify system configuration.

Course Objectives

Lesson 1:Course Introduction Lesson 2:Security Fundamentals Lesson 3:Intrusion Prevention Overview Lesson 4:Getting Started with the IDS Command Line Interface Lesson 5:Using IDM Lesson 6:Basic Sensor Configuration Lesson 7:Cisco Intrusion Detection System Alarms and Signatures Lesson 8:Signature Engines Lesson 9:Signature Configuration Lesson 10:Sensor Tuning Lesson 11:Alarm Monitoring and Management Lesson 12:Blocking Configuration Lesson 13:Cisco Intrusion Detection System Network Module Lesson 14:Intrusion Detection System Module Configuration Lesson 15:Capturing Network Traffic for Intrusion Detection Systems Lesson 16:Sensor Maintenance Lesson 17:Verifying System Configuration

Who Should Attend